If you highlight the nmc and go to performance...failure reasons...it should tell you why the alarm light is on. Todd ----- Original Message ----- From: "Marcelo Tadeu Mirabelli Marchesoni" <rede1@linkway.com.br> To: <usr-tc@mailman.xmission.com> Sent: Tuesday, January 28, 2003 8:58 AM Subject: Re: [USR-TC] NMC Hub Status
Jeff McAdams wrote:
Also Sprach Stephen Amadei
On Mon, 27 Jan 2003 mmm3@cornell.edu wrote:
Check the fans...make sure all are spinning. I had a hub status light go red because one fan went belly-up.
Ah... totally forgot about that. I'll check it next time I'm there... though it's stacked tight, so I have no idea how... ;-)
The fan trays are removeable.
At the front, there are two screws, one on each side, pointing sideways, unscrew those, then pull...hard. The whole fan tray will slide out.
There may be a couple of screws in back holding it into place as well, so check those.
Don't forget to release the third screw, on the chassis' back end.
-- [.........]s Marcelo Marchesoni rede1@linkway.com Sao Carlos - SP - Brasil
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc