Hello, all. I have a seeming simple, but irritating problem with getting a few analog/digital quads working with analog NIC's. I set them up for NIC, 115k fixed rate DTE, enable command echoing and response vie the DIP switch, but the best I've been able to get so far is a "yellow" off hook LED on a particular channel when issuing an ATDT5551212 - no responses ever show up on the terminal. And, I haven't been able to repeat that since it happened a couple hours ago. I've tried a variety of other oddments with the other serial options, and nothing seems to click. Also, is the DTE "slot" assignment even relevant when setting up the quads in this manner? Is there a specific setup, save to NVRAM, reset sequence I need to perform? I've even booted the cards with SW10 on to restore factory defaults to no avail (which is right on factory setup - 9600-N-7-1 or 19200-N-8-1?) These modems were previously used in "digital" mode, and functioned fine in that installation. I'm rather flustered at the moment, and it's no doubt something stupid and simple I'm missing. But, I would greatly appreciate any pointers from the gurus! Thanks, Brad