I think I have something different. It lost all IP settings, at the least, not just the default route. We also don't have any customers with routed connections... Thanks though, Charles On Mon, 31 Jan 2000, Richard Stuplich wrote:
I have seen this. I posted a question about this with no answer (yet). This is the default route taking off on you I would bet. I was dealing with this for a long time and found that the HiperARC doesn't deal with the radius properly (as far as I can tell).
This will break the default route:
mmanuf Password = "UNIX" User-Service-Type = Framed-User, Framed-Protocol = PPP, Framed-Address = 207.0.68.214, Framed-Netmask = 255.255.255.255, Framed-Route = "207.0.68.213 207.0.68.214 1" Framed-Compression = Van-Jacobsen-TCP-IP, Idle-Timeout = 0, Framed-MTU = 576
Where this will simply not work at all:
mmanuf Password = "UNIX" User-Service-Type = Framed-User, Framed-Protocol = PPP, Framed-Address = 207.0.68.214, Framed-Netmask = 255.255.255.255, Framed-Route = "207.0.68.213/32 207.0.68.214 1" Framed-Compression = Van-Jacobsen-TCP-IP, Idle-Timeout = 0, Framed-MTU = 576
Note: The first and 2nd work fine on Livingston/Lucent devices. In both above examples it does not work (route the 2nd IP address over the dialup). In the first case it breaks the rack be claminig the default route and in the 2nd it only does the promary IP address.
Check your radius users file for "Framed-Route" lines. These may be causing this.
Note: This is the 3rd rev of the code that still does this.
Charles Sprickman wrote:
Hi,
I was paged out of bed last night by an arc card that stopped responding to pings... I went into tcm to have a look, and all was green, but going to the config screen showed that the card had no IP address anymore. Doing a hard reset brought it back, and it's working fine. Has anyone else seen this? Just a fluke, or an issue with the 4.3.32-1 code?
Thanks,
Charles
-- =-----------------= = | Charles Sprickman Internet Channel | | INCH System Administration Team (212)243-5200 | | spork@inch.com access@inch.com | = =----------------=
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.
- To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.