If you have NI2 then you can't busy out channels. You need service messaging. Older versions of the HDSP software did a 'pretend' busy-out that worked even on NI2. Newer versions of software on the HDSP do busy out right by sending a service message. At 02:56 PM 4/1/02 -0500, you wrote:
With the new PRI's we're on, another problem is cropping up. Before, on a DSW100, we could soft-busy hung modems without affecting the other slots in the card. Now, soft-busying any modems throws the whole PRI into fast busies. We're told this is because the switch(NI2) doesn't accept service messages. Should we change to hard-busying hung modems? What's the difference?
Thanks,
-- Kirk Mitchell-General Manager mitch@keyconn.net Keystone Connect Unlock Your World Altoona, PA 814-941-5000 http://www.keyconn.net
_______________________________________________ USR-TC mailing list USR-TC@mailman.xmission.com http://mailman.xmission.com/cgi-bin/mailman/listinfo/usr-tc