Twice in the last week, our netserver has gone south. After much trial & error, I found I could revive it by: 1. Power cycling the router 2. Entering following commands: disable ip network ip163a delete ip network ip163a add ip network ip163a address 209.74.163.2/25 interface eth:1 enabled yes I have to enter these commands via seral port since for all intents & purposes, the ethernet port is dead. Any ideas? Only change we made in last couple of weeks was to give one of our clients 2 blocks of IP addresses as follows: set network user HBC1 ADDRESS_SELECTION specified remote_IP_address 209.74.163.209/29 ADD FRAMED_ROUTE USER HBC1 GATEWAY 209.74.163.209 IP_ROUTE 209.74.163.208/29 METRIC 2 add ip route 209.74.163.216/29 METRIC 5 GATEWAY 209.74.163.209 Should I handle this differently? Our System Version is V4.2.0 - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.