If you search on "hiper" and "management" you'll get hits on the HiperNMC Parameter reference, HiperNMC Getting Started Guide, HiperNMC Product Reference and a couple others. Brian <signal@shreve.net> on 10/07/99 09:57:03 AM Please respond to usr-tc@lists.xmission.com Sent by: Brian <signal@shreve.net> To: USRobotics TC Mailing List <usr-tc@xmission.com> cc: (Steve Valiunas/MW/US/3Com) Subject: (usr-tc) NMC Command Reference I am trying to get a handle on the Command Reference to use with HiperNMC 6.x. I don't see a HiperNMC 6.x command reference on TotalService. What I do see is: NMC version 5.0 parameter reference HiPer NMC Parameter Reference Errata Sheet HiPer NMC SNMP and MIB Reference Errata Sheet V6.0, 6.1, 6.2 That being said, are those the 3 files I should look at, or does a "HiperNMC version 6.0 parameter reference" exist somewhere? I am assuming you just go about using the 5.0 parameter reference with a few changes documented in the erattas........... Brian ----------------------------------------------------- Brian Feeny (BF304) signal@shreve.net 318-222-2638 x 109 http://www.shreve.net/~signal Network Administrator ShreveNet Inc. (ASN 11881) - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message. - To unsubscribe to usr-tc, send an email to "majordomo@xmission.com" with "unsubscribe usr-tc" in the body of the message. For information on digests or retrieving files and old messages send "help" to the same address. Do not use quotes in your message.