The reason you are getting busies once your first DSP is full is because the hiper arc doesn’t see your other 2 cards as shown with the ‘list chassis’ command.
Not sure why NMC awareness isn’t picking those up as you do have it enabled. Might try disabling it (disable nmc chassis_awareness) and then reenabling it. You also might have to reboot the NMC / ARC / DSP’s. If that doesn’t work for you, you can manually setup the DSP’s.
First disable chassis awareness. Then do something similar to the following: set chassis slot 2,3 card_type hdm_30
Todd
-----Original Message-----
From:
usr-tc-bounces+berto=core.com@mailman.xmission.com
[mailto:usr-tc-bounces+berto=core.com@mailman.xmission.com] On Behalf Of Shahrooz Sharghi
Sent: Tuesday, August
02, 2005 3:27 AM
To: Discussion relating to the
3Com/US Robotics Total Control modemsystems.
Subject: Re: [USR-TC] Hiper DSP
Sorry for mistake in sendind wrong attached file in my previous email.
HiPer>>
HiPer>> SHOW NMC SETTINGS
NMC SETTINGS
Chassis Awareness: ENABLED
Dynamic Slot Assignment: DISABLED
DSA Idle Rebalancing: ENABLED
SNMP Forwarding: ENABLED
HiPer>>
-------------------------------------------------------------------------------------------------------------
HiPer>> list chasSIS
Slot Owner
Description
Ports Type Console
1
YES 30 Channel High
Density Modem
30 DYNAMIC YES
2
YES
--EMPTY--
0 STATIC NO
3 YES
--EMPTY--
0 STATIC NO
4
YES
--EMPTY--
0 STATIC NO
5
YES
--EMPTY--
0 STATIC NO
6
YES
--EMPTY--
0 STATIC NO
7
YES
--EMPTY--
0 STATIC NO
8
YES
--EMPTY--
0 STATIC NO
9
YES
--EMPTY--
0 STATIC NO
10
YES
--EMPTY--
0 STATIC NO
11
YES
--EMPTY--
0 STATIC NO
12
YES
--EMPTY--
0 STATIC NO
13 YES
--EMPTY--
0 STATIC NO
14
YES
--EMPTY--
0 STATIC NO
15
YES
--EMPTY--
0 STATIC NO
16
YES HiPer Access Router
NAC
0 DYNAMIC NO
HiPer>>