18 Jul
2012
18 Jul
'12
4:36 a.m.
Joe - Do you mean 'reverse' to 'start' cutting the hole? - :>) Robbin - After you have 'reverse - marked' the hole - switch to 'forward' and cut the hole - the mandrel centering bit should be used to locate/cut the hole from the other side of the transom - same rev/fwd procedure .... you may have an open area -void- between the deck and hull depending upon where you cut - check 4 times- drill twice (pilot and saw). - Lenox bi-metal saws are a good tool for the job - you will be surprised how hard fiberglas laminate is on cutting edges. You know all this stuff- my gosh. Remember - always wear these...........safety glasses - per Norm Abram. Good idea - good luck. go