Gary, I ordered the thin Epoxy (3Qts from Raka), medium hardener, wood filler and 20-4” FG tapes. I am thinking a 4.5” angle grinder or a drill attachment disk would be used to remove the hull/deck sealant? I just want to make sure I understand your fix method before I start this later in week. 1. Open hull/deck up at transom. I guess pulling a inch or two apart wouldn’t crack the outer surfaces. 2. Remove sealant with sander-disk and wipe down with solvent. 3. Sand back (bevel) 2” from top of transom towards keel. 4. Fill the sanded back bevel area with thickened Epoxy and mate deck before Epoxy cures. 5. Rough up/fair top of transom-deck and new filled Epoxy and lay a couple layers of FG tape on. 6. Sand and fair. 7. Paint Is that correct? Erik Sent from my iPhone
On Jun 24, 2022, at 14:02, E Blohm <eblohm@rocketmail.com> wrote: