Well, I posted about this last night but I don't see my post showing up, so I will try again. I found the leak that Jim described (I bought his boat). About one inch aft of the bulkhead that supports the aft end of the v-berth, on the cabin sole, right in the center, is a small round depression in the fiberglass about the size of a quarter. From looking at the boat drawings, it looks like it is right above the pivot pin. There is a crack about 1" long across that small round area and I can watch water weeping slowly out of that crack. If I could figure out a way to post a photo, I would do that but there does not seem to be a photo option here - I can email one to anyone who asks. I have posted on the facebook page as well. The cabin sole was covered by a small carpet when I bought the boat and put it in the yard for the bottom paint job, so I don't know if the crack was there before the bottom job. Can I fix this in the water with something like marine tex? If I haul it on the trailer, can I fix it from above with real epoxy? Or do I need to get under the boat and fix it from the inside of the centerboard trunk? And, what could hav caused this? I am not sure of the purpose or cause of that little round depression in the glass.