Tod, Thanks for the link. This looks like good stuff. Jeff ----- Original Message ----- From: <htmills@bright.net> To: "'For and about Montgomery Sailboats'" <montgomery_boats@mailman.xmission.com> Sent: Monday, June 12, 2006 7:22 PM Subject: RE: M_Boats: mast question
How about Tef-gel?
http://www.spursmarine.com/tef_main.htm
Tod Mills M17 #408 BuscaBrisas
-----Original Message----- From: montgomery_boats-bounces+htmills=bright.net@mailman.xmission.com [mailto:montgomery_boats-bounces+htmills=bright.net@mailman.xmission.com ] On Behalf Of kingneptune46@netscape.com Sent: Monday, June 12, 2006 3:41 PM To: montgomery_boats@mailman.xmission.com Subject: Re: M_Boats: mast question
Hello Jeff,
I would use a stainless tang. That's the way it's been done since I can remember. If corrosion is a concern you can use "Lanocote" as a barrier between the parts. You could also use a nylon or rubber washer to increase separation. Since it's the forstay tang, just remove the masthead and bolt through and use a locknut- everything is well within reach. Or check Your masthead casting, there may be two holes that You could push a pin through. Mount a jaw toggle to that and You have an attachment point for the forestay. Just make sure You have a pin that fits snug through the holes on the masthead casting and also fits the Jaw Toggle. If You want I could go out and take a picture of My masthead then email it to You.
Part # for Jaw Toggles Scheaffer 93-65 Alex DJT-10
Have fun with Your project! and feel free to ask questions if you think any of this was helpful.
Mark Escovedo M17F/D #103 "AMY"
--- cjpacker@theofficenet.com wrote:
From: "Chris and Jeff Packer" <cjpacker@theofficenet.com> To: "For and about Montgomery Sailboats" <montgomery_boats@mailman.xmission.com> Subject: M_Boats: mast question Date: Mon, 12 Jun 2006 06:56:35 -0700
Any advice on mounting a cast aluminum tang for a forestay to my aluminum mast. A friend of mine says he always uses stainless steel machine screws and taps the holes into the aluminum mast when mounting hardware. I wondered about corrosion with Stainless and aluminum together. Is there any thread compound to use to help with this? What about pop rivets? Are they strong enough? and would I use aluminum or Stainless rivets?
Any comments would be appreciated. Jeff _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_____________________________________________________________ Netscape. Just the Net You Need.
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats