Ron: the hole saws we use in the shop are made by Lenox. link below so you can see pictures of the 'saws' - http://www.lenoxtools.com/pages/lenox-hole-saws.aspx use a hole saw for anything larger than 1/2". follow instructions for drilling hole as already shared by Sandy and Larry. -- :: Dave Scobie :: former M15 owner - www.freewebs.com/m15-named-scred :: M17 #375 SWEET PEA - www.m17-375.webs.com
On Sunday, June 15, 2014 9:38 PM, Larry Yake <larryyake@gmail.com> wrote:
Also, drill the first part of the hole in reverse. The teeth won't grab and chip the gel coat but will score a nice smooth groove. Do both sides this way before drilling on through.
Larry Y M17 CornDog
On Sun, Jun 15, 2014 at 9:12 PM, Sandy via montgomery_boats < montgomery_boats@mailman.xmission.com> wrote:
When using a hole saw, you drill from one side and the pilot drill penetrates the other side. Then switch sides, and drill from the. opposite side. That way you won't splinter the fibreglass.
-----Original Message----- Sent: Sun, Jun 15, 2014 4:54 pm
Hi, I need to add another through hull fitting to my M17 for a new bilge pump hose exit. I need to drill a 1" hole for my 3/4" fitting. I have a 1" wood drill bit but I'm afraid it will not make a clean cut. I looked in Home Depot and seen a 1" bit similar to a bit that you would use to drill out a door handle but the teeth were not close together so again I think it will cause some chipping. Can anyone confirm my doubts or suggest a type of bit to use..
Thanks, Ron McNeil M17/Jackpot/#675