Alex: Check out methods on - MSOGphotosite.com Search for 'lifting' :: Dave Scobie :: M17 #375 SWEET PEA - m17-375.com :: M6'8" #650 :: SV SWALLOW - sv-swallow.com On Mon, Mar 4, 2019, 5:25 PM Alex Conley <conley.alex@gmail.com> wrote:
Any recommendations on how to block an M15 up from its trailer to see/tend to the centerboard? I was all ready to splash her to make sire the board operates well when the world froze solid for an extra month.... On Mon, Mar 4, 2019 at 3:46 PM Dave Scobie <scoobscobie@gmail.com> wrote:
Jim:
When was the last time the centerboard was dropped and sandblasted? Rust scale on the cast iron board can stick it in the trunk.
:: Dave Scobie :: M17 #375 SWEET PEA - m17-375.com :: M6'8" #650 :: SV SWALLOW - sv-swallow.com
On Mon, Mar 4, 2019, 3:14 PM James Hymes <jamesehymes@gmail.com> wrote:
My CB has been stuck the past several times I've taken her (#69 M17(Not Coyote- I believe the boat named Coyote has the same number as mine, but was modified for racing - doesn't have a full cabin--but that 's not important right now). anyways, I drilled a 3/4" hole in the cockpit floor just aft of the doorway into the cabin above the CB . Drilled it there so that the steel rod will have good contact with the top of the stuck CB. I used a steel rod and a 10 lb sledgehammer, floated the boat but kept it on the trailer at the boat ramp. I was able to lower the CB a little, didn't have the motor so didn't want to have to struggle getting the boat back on the trailer in the wind - since it was not in open water I didn't get to see if it would drop all the way, will find that out next time. The last time I did sail with the CB up, it was too windy, and I was uncomfortable with the amount of heeling it did and also didnt point so well. I'm extremely hopefull the CB will drop all the way, cause if not I'll take ti and lift the boat on land and try wiggling the CB out while hitting it from above, may have to get drastic and cut open the keel and dig out the old steel slugs and replace with lead ballast - something I hope to avoid. If it works out, I'll put in some sort of plastic with a removable cap for the steel rod to fit into. I'll repost to let ya'll know if the sledge works. Jim in Denton Texas