I'm guessing there's no access from topside. At least I can't find any On Jun 3, 2017 10:10 AM, "Dave Scobie" <scoobscobie@gmail.com> wrote:
If there was any water intrusion into the board prior to her going on the trailer that water will slowly cause the steel punching to rust.
Could also be in the keel, from prior keel damage, and it's the daggerboard trunk that is swelling and sticking the board.
I think it is everyone's hope your issue is some stuck twigs, rocks, whatever between the board and trunk wall.
Rusting is not at all good or easy to repair.
:: Dave Scobie
On Jun 3, 2017 8:05 AM, "Steve w" <m35nc1@gmail.com> wrote:
What would cause the centerboard to swell. It hasn't been in water for years
On Jun 3, 2017 10:03 AM, <casioqv@usermail.com> wrote:
Be really careful with that method, only a very small amount of pressure can be applied safely with a rod. I tried this when I had a truly swollen centerboard, and had to tap the rod with a hammer. The rod went straight through the centerboard, and slipped sideways damaging the hull... without budging the centerboard.
Sincerely, Tyler
----- Original Message ----- From: "For and about Montgomery Sailboats" <montgomery_boats@mailman. xmission.com> To: "For and about Montgomery Sailboats" <montgomery_boats@mailman. xmission.com> Sent: Saturday, June 3, 2017 5:52:53 AM Subject: Re: M_Boats: Centerboard
Steve, A friend of mine used to have the issue of a sticking board because of small pebbles and debris washing down the drain hole. He used a narrow push rod to apply pressure from the topside to get the board to move. If course he knew it was stuck from debris and not a swollen trunk. I hope it's not due to rusting steel punches.
Skip M-15 #201 Wild Guppy
Sent from my iPhone
On Jun 3, 2017, at 8:16 AM, Dave Scobie <scoobscobie@gmail.com> wrote:
Oh.
Could be jammed ... Or could be rusting and swelled.
When I have a real internet connection, currently traveling so on smartphone, I'll look in archives for discussion on how to push the board down if stuck from Rock, mud, shells, etc. Or someone may share methods prior.
I hope it isn't rusting.
:: Dave Scobie
On Jun 3, 2017 6:12 AM, "Steve w" <m35nc1@gmail.com> wrote:
The boat was in a garage for 10 years. The owner has passed.
On Jun 3, 2017 8:10 AM, "Dave Scobie" <scoobscobie@gmail.com> wrote:
Steve.
Did the prior owner say the board was working?
:: Dave Scobie
On Jun 3, 2017 5:27 AM, "Steve w" <m35nc1@gmail.com> wrote:
Thanks Steve that's what I thought, however with the boat in the water and no tension on that line the centerboard still doesn't move. I swam under and tried to pry with a screwdriver. It doesn't move at all. I live NC in a community called Seven Lakes. That's where I'll start sailing her but I'd like to do some coastal cruising eventually.
> On Jun 2, 2017 10:59 PM, "Steve Trapp" <stevetrapp@q.com> wrote: > > Steve, > The centerboard on an M-15 is lowered by releasing the rope (line) that > is probably tied to a cleat on the seatboard across the cockpit at the aft > of the cabin. The centerboard cleat is next to the main-sheet cleat. Make > sure the release line (rope) is tied in the up position and securely to the > cleat before launching or outhauling your M-15 because any slack will get > the boat stuck on the trailer. > Where do you plan to sail your M-15, what body of water, what state? > Steve > M-15 # 335 > South Puget Sound > > > > -----Original Message----- From: Steve w > Sent: Friday, June 2, 2017 6:49 PM > To: montgomery_boats@mailman.xmission.com > Subject: M_Boats: Centerboard > > I just purchased an M15 and I can't figure out how to lower the > centerboard. If someone knows where I can get an owner's manual I'd > appreciate that as well. Thanks, Steve > >