Tom- Can you dribble a bit of lacquer thinner along the edge to soften the varnish, then clean it up with a very sharp putty knife? Might work. Are you still snowed in? Jerry jerrymontgomery.org ----- Original Message ----- From: "Tom Smith" <tsmith@nextit.com> To: "For and about Montgomery Sailboats" <montgomery_boats@mailman.xmission.com>; <cotmash@hotmail.com> Sent: Tuesday, May 30, 2006 10:35 AM Subject: RE: M_Boats: Cleaning up varnish I've got a bit of cleanup to do on a teak toe rail. The rail was varnished in haste by a former owner (not Bill), and there's a fillet of varnish along both the inside and outside of the rail where it joins the deck. It's been on there a while, so a sharp blade won't do the job. All the chemical strippers I'm familiar with are harmful to glass, so unless someone has a non-volatile suggestion, that's out. My best alternative thinking on my own is a sharp edged sanding block. Any other suggestions? t Tom Smith & Jane Van Winkle M17 #496 _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats