Tyler If you have a cleat on both the P & S side of the stern going through both the Hull & Top Pan along with a forward deck cleat with a proper backing plate the M15 can be lifted with a 3 point harness. This was done during a Hull fiberglass repair this past season on mine. A little experimentation might be needed to adjust the harness lengths. Note the rear 2 always remaining the same length..Possible Jerry M. might speak to this? George MerryHelen II 96 M15 #602 "We Can Not Control the Wind But We Can Adjust Our Sails" On Thu, Mar 24, 2022 at 8:33 PM David Grah via montgomery_boats < montgomery_boats@mailman.xmission.com> wrote:
Hey there, Tyler. I have no experience with hoists (though have been interested in the hoist at Avila Beach since there is no ramp there either) though remember when I repainted the bottom of my Montgomery 15, and based on recommendations from this group, I lifted from the rear holes on the "chain plate" brackets the shrouds connect to. That left the boat a little stern-heavy so I needed something to provide a little bit of support to hold the stern up. Although loads for this purpose were almost static compared to what might be somewhat dynamic loads on a hoist, it worked well. I suppose this same approach could work with a hoist. David GrahBishop California Date: Thu, 24 Mar 2022 13:33:10 -0700 (PDT) From: casioqv@usermail.com Subject: M_Boats: M15 hoist lifting bridle or sling To: For and about Montgomery Sailboats <montgomery_boats@mailman.xmission.com> Message-ID: <646072963.340598461.1648153990259.JavaMail.zimbra@usermail.com> Content-Type: text/plain; charset=utf-8
Hi All,
My yacht club doesn't have a boat ramp, but does have a hoist for lifting sailboats that I am interested in trying with my M15. The hoist is a single point (hook). Does anyone here have any experience or suggestions on what type of lifting bridle or sling I could use for an M15? Would it be okay to lift by the chainplates, or should I plan on straps that go under the hull?
Sincerely, Tyler '81 M15 #157 Defiant