16 Jun
2014
16 Jun
'14
3:54 a.m.
Hi, I need to add another through hull fitting to my M17 for a new bilge pump hose exit. I need to drill a 1" hole for my 3/4" fitting. I have a 1" wood drill bit but I'm afraid it will not make a clean cut. I looked in Home Depot and seen a 1" bit similar to a bit that you would use to drill out a door handle but the teeth were not close together so again I think it will cause some chipping. Can anyone confirm my doubts or suggest a type of bit to use.. Thanks, Ron McNeil M17/Jackpot/#675