19 May
2016
19 May
'16
2:06 p.m.
Great hearing about the progress, Mike. On Thu, May 19, 2016 at 2:44 PM, michael beebe via montgomery_boats < montgomery_boats@mailman.xmission.com> wrote:
M17 centerboard, thanks everyone for all the help on the CB. After reading I find I was on the right tract. I made a cardboard pattern using a tick stick, transferred to 1/4" ply, used a marker to find pivot pin point, drilled ply, inverted 1/2" pivot to check swing, went to fabricater and he cut it out of 1/2" plate, drilled both holes, being epoxied as I write, using cutting board plastics for shims. I can feel the movement on the water. Thanks again, Mike.