George, My first Montgomery sprung a leak when the end of a bunk board forced a dimple into the hull from the outside. When you do that the inside corner of the simulated planking will develop a crack and let in some water, maybe a lot of water. I got a cardboard tube from a rug shipment, cut it in half the long way and classed it inside so that it took the load of the bunkboard in that area and prevented acute flexure either on the edge or the end of a bunkboard. I then also glassed the crack, actually before I put the half tube of cardboard over it fore to aft and heavily glassed that into the hull. Good luck, Tom B <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail&utm_term=icon> Virus-free. www.avast.com <https://www.avast.com/sig-email?utm_medium=email&utm_source=link&utm_campaign=sig-email&utm_content=webmail&utm_term=link> <#DDB4FAA8-2DD7-40BB-A1B8-4E2AA1F9FDF2> On Tue, May 17, 2016 at 9:27 PM, Stan Susman <stanpfa@pacbell.net> wrote:
I suggest you find the leak
Sent from Yahoo Mail for iPhone <https://yho.com/footer0>
At May 17, 2016, 7:13:34 PM, George Iemmolo wrote: After yesterdays fiasco of the Mast falling I thought bad things were over for the season. No such luck went out to boat this morning and found cabin with water nearly up to bench height. Pumped out by hand and had to leave as my 1st wife of 60 years was scheduled for hand surgery.
Returned to boat in evening with trailer and found water at the previous level. Hauled out and parked in marina lot. Left some water in cabin and found leak on Port side close to forward end of bunk board. Need to determine cause and method of repair.
Any suggestions?
George "We Can Not Control the Wind But We Can Adjust Our Sails"