Hooray! That is a load off my mind. whew. I guess I'm just a bit nervous about unexpected issues with my darling M15. I went out sailing locally today and everything on the boat worked perfectly (especially the 4 horse motor I got yesterday). No water ingress into the bow locker, either, so the water in there must have been residual. Also, had some FANTASTIC wind. I can't seem to get the weather to check, but I'd say 15 gusting to 20, at least. FUN stuff! Thanks everyone! Cheers! Chris M15 Persephone On Sat, Aug 1, 2009 at 4:51 PM, Bob From California <ocean37@hotmail.com>wrote:
Chris..
Don't cancel a trip over something not serious.
Really, this is a non-issue. Steel rusting trim ballast is nothing to worry about.
Clean it up over the WINTER.....Dig it out and throw in some lead shot from the Gun Store; Cover it with some mat and cloth. Not a big deal.
Wait until winter. This issue has nothing to do with the integrity of the hull.
GO SAILING and REPORT BACK...
Bob
Date: Sat, 1 Aug 2009 13:31:16 -0500 From: chris.r.smith@gmail.com To: montgomery_boats@mailman.xmission.com Subject: M_Boats: Swollen interior of hull
So I was gearing up for my trip to Superior today and thought I'd give my M15 a good once over. I looked in the bow locker (which I almost never use) and noticed that there was a swollen bit of the hull about 5 inches from the aft edge of the locker. Not only was it a bit wet in the locker, but the swollen bit (about 5 inches across, running laterally) had pushed up what appeared to be a fiberglass patch pretty significantly, cracking it open and exposing what looked to be rusting metal. Upon further inspection, there were some holes at the joint where the aft locker wall meets the hull - no rusty metal there, but it was unclear if they were supposed to be there as they were irregularly shaped..
Seeing as the boat was salvage from the bottom of the ocean in TX, I figure salt water got in there and is slowly destroying whatever in between the layers of fiberglass.
I'm going to put off the trip to take the boat out and see if water is actively getting in there and how.
My questions are these:
1. Is it rusting metal that I see? 2. What can I do about it? 3. Should there be any openings into that locker? perhaps for water to get out? or to the bilge?
I had my brother shine a light up into the keel to see if it was open to that, but didn't see any light. The hull seems sound - I've been sailing it for years with no problem, and have patched anything remotely like a crack from the outside, so it's a bit of a mystery to me how water is getting in there.
Thanks for the help/advice!
On Wed, Jul 29, 2009 at 10:01 PM, bownez@juno.com <bownez@juno.com> wrote:
Jerry,
Thank you for the enlightenment. (again).
Bones
____________________________________________________________ Keep your hair. Click for permanent solution to hair restoration
http://thirdpartyoffers.juno.com/TGL2141/fc/BLSrjpTKuxJsol7WCOMM67b0kwEQGJh5...
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
Remember, there is no privacy on the Internet!
-- Chris _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
Remember, there is no privacy on the Internet!
http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
Remember, there is no privacy on the Internet!
-- Chris