Gail. The rudder simply lifts off vertically. No unbolting required. The tiller pivots on one bolt (3/8) simply unbolt by removing the lock nut and pull the bolt out. I built a 2 position mast carrier for this boat. Low position for trailering and high position when you need an angle to raise the mast. You can see it in this photo........in the up position. [cid:0FFFC0ED-26F2-4D6D-B232-4096610FA259] Sent from my iPad On Feb 2, 2021, at 1:42 PM, Gail Russell <gail@zeliga.com> wrote: I have taken a photo and attached to an email, but it awaits approval. The rudder and tiller are integral with the mast, but they do not appear to me to be inseparable. I can post the pictures to Facebook and get more as needed. It appears to me that three bolts will remove the blade of the rudder, but it has to be unwound from the rope of the kickup assembly, which is not obvious. It initially appeared to me that I could lift out the tiller along with its vertical mounting, but it may involve the mast system. I could unbolt the tiller from its mounting. On Tue, Feb 2, 2021 at 12:52 PM Dave Scobie <scoobscobie@gmail.com> wrote: Thomas: Some RudderCraft rudder setups have a mast crutch system. If this is on Gail's new-to-her boat the rudder must stay on the transom in order to support the mast crutch to support the mast. (This also assumes that there is no stand-alone mast crutch to put on the tansom ... again this depends on what the prior owner(s) have done with the boat.) :: Dave Scobie :: SV SWALLOW - https://sv-swallow.com :: Montgomery 6'8" #650 :: Truck camper - https://truckpopupcamper.wordpress.com/ :: Ramblings - https://scoobsramblings.wordpress.com/ :: former M17 owner #375 SWEET PEA - https://m17-375.com/ <http://www.m17-375.webs.com/> :: former M15 owner #288 - http://www.freewebs.com/m15-name-scred On Tue, Feb 2, 2021 at 12:37 PM Thomas Buzzi <thomaspbuzzi@gmail.com> wrote: I have a Ruddercraft Rudder and it is simply hung off the transom on only gudgeons and pintles. What is a mast structure that is involved?? On Tue, Feb 2, 2021 at 2:29 PM Dave Scobie <scoobscobie@gmail.com> wrote: Gail: what is the rudder arrangement? if the rudder is a RudderCraft with an integrated mast support it CANNOT be removed when towing/transporting. :: Dave Scobie :: SV SWALLOW - https://sv-swallow.com :: Montgomery 6'8" #650 :: Truck camper - https://truckpopupcamper.wordpress.com/ :: Ramblings - https://scoobsramblings.wordpress.com/ :: former M17 owner #375 SWEET PEA - https://m17-375.com/ <http://www.m17-375.webs.com/> :: former M15 owner #288 - http://www.freewebs.com/m15-name-scred
