Just realized that the spelling is Wallas, not Wallis ----- Original Message ----- From: "Steve & Diana Parsons" <sparsons@canby.com> To: "For and about Montgomery Sailboats" <montgomery_boats@mailman.xmission.com> Sent: Thursday, September 27, 2007 7:08 AM Subject: Re: M_Boats: Heater
On my CDory, we use a Wallis diesel heater that vents to the outside of the boat. This is clearly too big for anything but a M23, but you might look around to see if they or a competitor makes a similar model in a size that would be appropriate for a M15 or a M17. Caveat... The Wallis is a fixed mount, so you would need a dedicated "galley" area.
With the lid down, there is a small fan that runs and distributes air in the cabin. With the lid up, it serves as a very good stove. To conserver power, we use an eco-fan (creates its own electricity from the stove's heat to power the fan) to distribute the air. Keeps the inside of a CDory 22 Cruiser very comfortable. As the exhaust is over the side, no moisture or CO.
They are supposed to run on #2 diesel, but most of the CBrat crowd run Klean-heat.
Regards,
Steve ----- Original Message ----- From: "Larry E Yake" <leyake@juno.com> To: <montgomery_boats@mailman.xmission.com> Sent: Wednesday, September 26, 2007 5:02 PM Subject: Re: M_Boats: Heater
I tried the same heater, Tod, but found that having the hatch open far enough to make me satisfied I wasn't going to suffocate let in more cold air than the heater could warm up.
I didn't realize catalytic heaters produced moisture. It would be nice to find something that helped eliminate condensation while warming the cabin.
Larry
On Wed, 26 Sep 2007 18:40:06 -0400 <htmills@zoominternet.net> writes:
I tried a Coleman SportCat catalytic heater, but the amount of water vapor produced negated the benefits of some heat, I thought, so I quit using it.
Tod Mills M17 #408, 1987 galley model BuscaBrisas
-----Original Message----- From: montgomery_boats-bounces@mailman.xmission.com [mailto:montgomery_boats-bounces@mailman.xmission.com] On Behalf Of Nebwest2@aol.com Sent: Wednesday, September 26, 2007 9:41 AM To: montgomery_boats@mailman.xmission.com Subject: M_Boats: Heater
Yes it's true,
Sleeping on the boat while it was on the trailer (boat is unable to weather
vane) the wind came up pretty strong from the stern. Our CO alarm did go off even though the heater was outside. We finally figured out the wind must have been blowing across the heater and up to the weather boards allowing a little exhaust in?? Turned the trailer around, aired out the boat, reset the alarm, and didn't have any other problems. As long as the heater is outside, and I have the CO alarm inside I feel comfortable. But that's just me. You have
to make your own decision. I know a lot of folks that "crack" the hatch and use things like Origo heat pals or Coleman catalytic heaters inside. That I wouldn't be comfortable with. You'll have to make your own call.
Gary's advice is sound. You can't get CO poisoning if you don't make any CO!
************************************** See what's new at http://www.aol.com _______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
No virus found in this incoming message. Checked by AVG Free Edition. Version: 7.5.488 / Virus Database: 269.13.28/1021 - Release Date: 9/21/2007 2:02 PM
No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.488 / Virus Database: 269.13.28/1021 - Release Date: 9/21/2007 2:02 PM
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats