Neil We switched to all rope. The new stuff is strong and doesn't stretch. Easy to make the halyards longer for running aft for singlehanding. The problem with the wire/shackle is limited movement. Bob Eeg (949) 489-8227
Date: Wed, 7 Jul 2010 09:09:06 -0700 From: Larry.Hughston@dgs.ca.gov To: montgomery_boats@mailman.xmission.com Subject: Re: M_Boats: Advice sought - wire to rope halyard
Neil, if this any help, I use Stay-Set double braided for my halyards. Green tracer starboard, red tracer port. Either 1/4" or 5/16". Use either Jamestown distributors or West Marine (but only when a sale is on). Duckworks is good too but they have a limited selection of tracer colors.
Do you have downhauls on your Monty? I have my jib rigged but not the main....that is next.
Where are you headed next for sailing? ----Larry Hughston Old 189.
-----Original Message----- From: montgomery_boats-bounces@mailman.xmission.com [mailto:montgomery_boats-bounces@mailman.xmission.com] On Behalf Of ndorf@surfbest.net Sent: Wednesday, July 07, 2010 7:20 AM To: montgomery_boats@mailman.xmission.com Subject: M_Boats: Advice sought - wire to rope halyard
Hey guys,
Looking for some advice here on how to make my main halyard safer.
The wire-to-rope connection on my '85 M15 has proven to be unsafe and prone to tangles. It is rigged up exactly the way it was when I acquired it from the previous owner. The wire piece terminates with a shackle, as I believe it should, but the rope end seems to be rather kludgy).
The end of the rope part of the halyard is tied to a snap-type shackle. Rather than the shackle being just snapped on to the wire end shackle, it is fed through and then snapped back on the rope. While this arrangement has proven to be secure enough, the problem is that it creates a big bulge (think pig in the snake), right at the point with the two shrouds affix to the mast and also near the top of the fore-stay. Any amount of accidental buffeting in the wind of the halyard, while raising or lowering the main, causes the wire to rope joint (weighty such as it is) to easily get twisted and caught up top around the standing rigging. And when it happens, (Murphy's Law) it happens at the worst possible time.
My question is, what is the factory standard setup for the main halyard? Was there supposed to be an eye splice at the end of the rope halyard? Bowline? Buntline?
When it comes to sewing I'm all thumbs so I'm not inclined to try doing my own eye splice, so I'm hoping to hear that some other method has proven to be effective and reliable.
Thanks all,
Neil Dorf 1985 M15 #334 Roseville CA
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
Remember, there is no privacy on the Internet!
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
Remember, there is no privacy on the Internet!