Dave: Or maybe the sun shone on that window a lot when the boat was not in use? ⎈--Gary ☺ On Mar 23, 2010, at 5:00 PM, W David Scobie wrote:
Neil:
i believed that the current build and older Mboats use the same shaped cabin windows ... and bob e. confirms! we monty's are lucky that the boat is still in production!
$20 bucks ... lot less than collecting the material, bit(s), cutting (and mistakes), etc.
i need to replace SWEET PEA's windows. the port window is so crazed as to be almost impossible to see out. this is the window over the galley, so i wonder if heat is the cause as the starboard windows have 1/10th the crazing?
SWEET PEA spent most of her 'before me' life on-buoy 1/2 the year. the usual orientation in her anchorage was port side facing the afternoon and evening sun. the starboard faced a tree-covered shore.
nothing lasts forever!
dave scobie M17 #375 - SWEET PEA visit SWEET PEA's www-site - http://www.m17-375.webs.com
--- On Tue, 3/23/10, Bob From California <ocean37@hotmail.com> wrote:
Neil....
Why Lexan..?..Lexan cannot be tinted and it scratches easily.
We use ACRYLIC smoke tinted windows on the production M Boats and they are 1/4 inch thick.
Why spend the money $ on a Router Bit and a half sheet of Lexan or Acrylic when you can buy new windows already to install for $20 each from us...?
They come cut out and all you would have to do is have someone hold them in place while you back drill the new holes. We use Marine Silicon (no mold issues).
Fair winds, Bob www.montgomeryboats.com www.norseayachts.com (949) 489-8227
From: ndorf@surfbest.net Date: Tue, 23 Mar 2010 16:49:44 -0700
Jerry,
Thanks for the reply. Hope yourTucson trip was enjoyable. Can the Lexan cutting be done with a dremmel tool and the appropriate disc?
-----Original Message----- From: jerry <jerry@jerrymontgomery.org> Sent: Tuesday, March 23, 2010 2:48 PM
They are undercut at 45 degrees, which we did on a router. If you have and are familiar with routers, get a carbide 45 degree bit and carefully make a pattern off the old one. I don't think you could cut one with a bandsaw; it would chip and fuzz up too much.. Have fun!
jerry ----- Original Message ----- From: <ndorf@surfbest.net> Sent: Tuesday, March 23, 2010 12:42 PM
I would like to redo my M15 port lights with new Lexan and was thinking I could use the existing ones as a template for the new ones. But I can't tell for sure until I remove them if they would actually lay flat or are slightly concave.
It looks like what's entailed is removing all the screws and I suppose there is some silicone caulking / adhesive sealant underneath...
Anyone know, or attempted this?
thanks, Neil
_______________________________________________ http://mailman.xmission.com/cgi-bin/mailman/listinfo/montgomery_boats
Remember, there is no privacy on the Internet!