Wow. As always , impressed with the wealth of info from Monte owners group. Thank you. Ed Sent from my iPhone
On Dec 28, 2020, at 9:18 AM, Thomas Buzzi <thomaspbuzzi@gmail.com> wrote:
Before using the product I gave the hull a thoro detergent and scrubbing to remove loose dirt. The product said that a light oxidation could be left in place. They were correct. Yes, as just mentioned, I think the product is now NewGlass 2. It also has a chemical stripper available to remove the old should you ever need to. Apply carefully and smoothly. Try to work off a wet edge whenever possible and work continuously to a corner or break in the hull design. Using their remover required a lot of remover and lots of clean rags. Best to get it right the first time, which is easy to do anyway.
On Mon, Dec 28, 2020 at 11:11 AM Gail Russell <gail@zeliga.com> wrote:
How did you prep the area?
On Mon, Dec 28, 2020, 8:37 AM Thomas Buzzi <thomaspbuzzi@gmail.com> wrote:
On my 1977 Monty 17 I used a liquid polymer called NuGlass. It goes on with a chamois applicator which is a piece of gray pipe foam insulation wrapped with a piece of chamois available at Walmart. I put mine about 4" wide so one swipe of it along each plank on the Monty 17 left a complete covering for that strake. If your gelcoat needs only a bit of sanding to remove the oxidation this is the stuff to use. I applied about five coats on the hull. It dries so fast that when you finish the first coat you can start all over again with the next coat. I started from the top and worked down so any drips can be wiped up as you go down the hull. It took about 45 minutes to apply the five coats. It renders a deep shine that is hard and lasts for about three years. Then just wipe on more right over the old. There is a picture of the before and after on my boat as I did one side at a time. The MSOG photosite has my boat pictures, named AS-IS. I have waxed and buffed before and this treatment gives as good as or better results and is very quick! Full disclosure, I have no direct business contact with this particular company just a happy customer. Fair winds, Tom B
On Mon, Dec 28, 2020 at 10:06 AM Edward Epifani <edepifani@hotmail.com> wrote:
Hey Skippers, Anyone have experience with M15-23 gelcoat restoration ? My boat previously was a Dream Boat: she sat in the sun while the owner mostly dreamed. My impression is that JM used very good technique/ materials, the damage seems minimal compared to what I’ve seen on equivalent age sun stored boats. So I’d describe the oxidation as light/moderate. I’m looking at a shurhold polish/ buffer. I’m well aware of the danger of over zealous circular polishing, seems more likely with lapstrake hull form. The Shurhold is orbital and smaller. Also would love to hear about nonskid cleaning/ restoration experience. Ed Epifani M15 ‘83, #200 something
Sent from my iPhone